发布时间：2018-12-11 08:28| 分享到：
Due to the low temperature in winter, the home decoration construction should be especially concerned. Although the construction of the room decoration is not large, it includes conventional work such as water, wood, electricity, tile, oil, etc. Due to the special nature of the season, there will be some decoration problems in the winter decoration. How to solve the winter decoration problem? Let's take a look at the Xiaobian, which is decorated with Tai'an Greenland.
Winter decoration problem one, veneer cracking
Solution: After the decorative panel is shipped to the site, use a dry towel to wipe off the floating dust and apply the varnish back cover twice. All decorative panels should be flattened, with a large core plate at the bottom and a large core plate on top, so that the plate can be kept flat and not placed vertically, thus preventing the panel from cracking and lifting.
Winter decoration problem 2, wall cracking
解决办法：常开窗通风，时间最好选在上午10点至下午4点之间。这一段时间温度相对高些，可以防止新刷的腻子 冻结。等第一遍腻子完全干透后，再刷第二遍腻子；第二遍腻子完全干透后，再用砂纸仔细打磨。墙面出现较大裂缝时，局部的地方双贴牛皮纸再刷腻子，面积较大 时最好贴上的确良布，再涂刷腻子，这样可保证墙面的平整、不开裂。
Solution: Always open the window for ventilation, the best time is between 10 am and 4 pm. This time the temperature is relatively high, which prevents the new putty from freezing. After the first time the putty is completely dry, brush the putty for the second time; after the second time, the putty is completely dried, and then carefully sanded with sandpaper. When there is a large crack on the wall, the local place is double-applied with kraft paper and then putty putty. When the area is large, it is best to stick the good cloth and then apply the putty, so as to ensure the wall is flat and does not crack.
Winter decoration problem three, ceiling crack gypsum line cracking
Solution: When carrying the gypsum board ceiling, the joint between the gypsum board and the gypsum board and the wall surface should leave a gap of about 1 cm, first fill the gap, then double the kraft paper, then brush Putty. When sticking the plaster line, let the gypsum board have a gap of about 5 mm with the top surface and the wall surface, and use gypsum powder and latex to adjust the joint filling to prevent the plaster line from cracking.
In addition, before construction, according to the influence of temperature and humidity on materials and processes, the decoration company should be equipped with humidification and heating equipment on site to adjust the construction site environment to meet the process requirements; at the same time, for wood, wall and floor tiles, paint, etc. The materials were classified and processed in a constant temperature and constant humidity for three days. After completion, three days of indoor and outdoor convection ventilation shall be carried out to observe carefully whether there is any unexpected change. As long as you pay more attention to the problems that are easy to occur in winter, you can ensure the smooth completion of home improvement.